EasyManuals Logo

Expobar BREWTUS III User Manual

Expobar BREWTUS III
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
6. Water Softener (Brewtus III V only)
The Brewtus comes with a water softener that will help keep damaging minerals out of
the boilers. There is nothing that has to be done on initial start-up to get the water
softener ready for use. See the chart below for recommendations on when to recharge the
water softener. Use the following recharging instructions.
Water softener filter Water reservoir
a) Fill a container with water (same amount as the reservoir)
b) Pour in 3 tablespoons of salt.
c) Stir the salt into the water.
d) Insert the water softener filter inside the reservoir.
e) Drain the water from the reservoir through the water softener filter.
To drain the water from the reservoir:
Place the plastic tube as is indicated.
Suck in the tube until it fills with water.
Press your finger over the inlet from the tube in order to avoid any air.
While the tube is being pressed, place the inlet from the tube downwards
(as indicated). Wait until the reservoir is completely empty.
Once the water reservoir is empty, fill it again with water (without salt) and repeat
the process, in order to clean the water softener filter.
Plastic tube
Drain the water from the tank
this way
Water tank filled with salty water
Water softener filter
Salty water outlet
Litres of softened water, depending on its hardness
(In French Degrees)
Salt
Water
Hardness
20 30 40 60 80
Grams
Maximum
Volume of water
softened by filter
11 9 8 7 5 300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Expobar BREWTUS III and is the answer not in the manual?

Expobar BREWTUS III Specifications

General IconGeneral
BrandExpobar
ModelBREWTUS III
CategoryCoffee Maker
LanguageEnglish

Related product manuals