What to do if my Expobar New Elegance does not start up?
If your Expobar Coffee Maker doesn't start, the circuit breaker or differential might be disconnected. Check to ensure they are properly connected. Also, the cable or plug could be damaged, in which case you should call service personnel to replace them.
Why is my Expobar New Elegance coffee dispensing very fast?
If the coffee dispensing from your Expobar Coffee Maker is too fast, it's likely that the coffee grinding is too coarse. Adjust the coffee grinding setting to a finer grind.
Why is my Expobar Coffee Maker coffee dispensing very slow?
If the coffee dispensing from your Expobar Coffee Maker is too slow, it's probably because the coffee grinding is too fine. You should adjust the coffee grinding setting to a coarser grind.
What to do if the steam wand on my Expobar New Elegance Coffee Maker does not dispense steam?
If the steam wand on your Expobar Coffee Maker isn't dispensing steam, it might be clogged by milk. Clean the wand. If that doesn't work, remove the nozzle and unclog it using a pin or needle.
Explains the meaning of DANGER, WARNING, and IMPORTANT signal words.
Provides guidelines for safe installation, use, and maintenance.
Lists manufacturer liability and general safety warnings for installation.
Lists safety measures to follow before and during operation.
Defines the machine's purpose and limitations for safe operation.
Details specifications for the New Elegance IGR models.
Details specifications for the New Elegance Control 2GR models.
Details specifications for the New Elegance Display Control models.
Provides dimensional drawings and data for MINI IGR models.
Provides dimensional drawings and data for MINI 2GR models.
Provides dimensional drawings and data for MINI IGR with grinder.
Guides on placing the machine for optimal installation.
Provides safety, connection guidelines, and types for electrical hookup.
Illustrates various electrical connection types for the machine.
Details requirements for connecting to the domestic water supply.
Explains boiler pressure and temperature relationship.
Steps to follow to start the machine for the first time.
Outlines routine maintenance tasks for the machine.
Step-by-step guide for replacing the group gasket.
Explains the functions of the electronic control panel and buttons.
Explains the various counters for tracking machine usage.
Details how to navigate and view different counters.
Describes the service alert counter and reset method.
Procedure to restore the machine's settings to factory defaults.
Instructions on how to enter the service programming mode.
Enables or disables user modification of coffee doses.
Enables/disables the coffee dispensing speed monitor.
Sets minimum and maximum dispensing speeds for the grinding alert.
Sets the number of coffees before a maintenance alert.
Adjusts the temperature setting for the boiler.
Explains independent digital temperature adjustment for each group.
Details how to connect or disconnect individual thermostats.
Guides on adjusting the group temperature via the thermostat.
Procedure to reset thermostat parameters to factory defaults.
Explains error messages related to thermostat faults.
Service intervals for Mini Control IGr & 2Gr components.
Service intervals for Display Control 2Gr & 3Gr components.
General| Brand | Expobar |
|---|---|
| Model | New Elegance |
| Category | Coffee Maker |
| Language | English |
To Next Page
