New Elegance
INSTALLATION AND START UP
Pressure and temperature
Standard pressure and temperature
Fig. 01
Relationship between boiler pressure and temperature
Water connection
110
115
120
125
0.7 0.8 0.9 1.0 1.1 1.2
Important:
Only use the hoses supplied with the machine. Never reuse hoses.
Make sure that the drainage tube is not twisted and ensure that the entire tube is below the level of the
drain cup.
Starting the machine
BAR
O
C
Connecting the machine to the domestic water supply must be performed by a qualied person.
Purge at least 20 liters of water from the domestic water supply before connecting the machine to it to ush out any debris that
may be in the plumbing sytem that would otherwise accumulate inside the boilers.
The domestic plumbing system should be tted with a brass 3/8” NPT male pipe tting and an in-line shut-off valve.
Connect the 180cm water inlet hose included with the machine to the domestic water supply and tighten the line
ttings with a wrench to 15 ft. lbs. / 20N-m.
Only use safe drinking water with a hardness rating between 5ºfH and 8ºfH (French hardness degrees) or 20 to 32
ppm (parts per million as calcium). If the hardness value is below this limit, corrosion of hydraulic components is likely.
If the value is higher, lime-scaling inside the boiler will occur. In both cases, the proper function of the machine and
quality and taste of the coffee will be negatively affected.
If necessary, connect the machine to a water softener to reduce water hardness using the exible 55cm hose included in
the accessory box.
Connect one end of the corrugated drain tube to the drain cup in the machine, connect the other end to the plumbing
drainage system in the installation area.
Boiler pressure is directly controlled by water temperature (g. 01).
This machine is tted with a pressure gauge that displays the boiler pressure, if the machine is equipped with a digital
display it will also indicate water temperature.
Open the machine’s water supply valve.
Turn on the main power switch.
Press a drink button at the control panel on each group, wait until water
comes out continuously from each of them. This ensures that the heat
exchangers in the machine are being correctly lled.
Open the steam lever to release the air trapped in the boiler.
The red lamp indicates that the boiler is heating. The lamp switches off
automatically when the machine reaches operating temperature.
The machine is now ready to use.
To Next Page
Loading...
