Expobar New Elegance - Programming Functions; Electronic Control Panel and Buttons

25
R
New Elegance
Electronic control panel
PROGRAMMING
The electronic keypad controls the following functions:
Volume control of four different espresso drinks per brewing group.
Time-controlled hot water dispensing. (if available)
Automatic lling and level control of the boiler.
Automatic switch off of the heating element if not enough water.
System supervision through alarms.
RS-232 serial interface with reader for connecting control panel and computer.
Automatic cleaning of the brew groups.
The control panel is by default programmed with 4 standard drinks (these can be reprogrammed as you wish) and a
continuous selection. The rst four keys (1 short espresso, 1 long espresso, 2 short espresso, 2 long espresso) brew
the programmed volume and then stop automatically, the fth key brews continuously until user stops it by pressing
button again.
To activate these functions, turn off the machine at the power switch then, while holding down the
required button on the left-hand Drink buttons, turn the machine back on.
1 Short Espresso. Enable electronic pre-infusion.
1 Long Espresso. Disable electronic pre-infusion.
2 Short Espressos. Perform auto-cleaning.
Button functions
Additional button functions
1 Short Espresso
1 Long
Espresso
2 Long
Espressos
Programming
Continuous Dispensing
Hot water / Automatic steam
(if enabled)
2 Short Espressos/
Auto-cleaning
The Continuous Dispensing button performs 3 different functions (depending on length of time pressed):
Machines with display
Under 1 second: Enables automatic water- or steam-dosing (only on machines without manual taps).
Between 1 and 8 seconds: Enables Continuous Dispensing (press again to disable).
Over 8 seconds: Access coffee-dose programming menu (see below).
Machines without display
Under 4 seconds: Enables Continuous Dispensing (press again to disable).
Over 4 seconds: Access coffee-dose programming menu (see below).
Note:
In machines equipped with a display, electronic pre-infusion may have to be enabled/disabled
from the service programming menu.
i