C-12 CRUSHER
SETTING MATERIAL OUTPUT SIZE:
The C-12 crusher has an adjustable discharge setting capacity. To set the size of the output material, carry
out the following procedure :
WARNING:- The machine MUST be stationary and the crusher turned off
whilst this procedure is carried out.
2:- Restart machine as described on page 8 and
leave speed switch at position No.1.
1:- Stop the machine as described on page 9.
NOTE :- MACHINE MUST BE SHUT DOWN AND RESTARTED
(SEE STEPS 1 & 2) BEFORE JAW CAN BE OPENED / CLOSED.
Ignition Key
19
To Next Page
Loading...