Need help?Do you have a question about the Extech Instruments EX205T and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Diode Test | Yes |
| Continuity | Yes |
| Data Hold | Yes |
| Backlight | Yes |
| Battery Type | 9V |
| Safety Rating | CAT III 600V |
| Display | LCD |
| DC Voltage | 200mV/2V/20V/200V/600V |
| AC Voltage | 200V/600V |
| DC Current | 200µA/20mA/200mA/10A |
| Resistance | 200Ω/2kΩ/20kΩ/200kΩ/2MΩ |
| Frequency Range | 10MHz |
| Temperature Measurement | -40°C to 400°C |
Brief overview of the Extech EX205T multimeter and its purpose.
Explanation of overvoltage categories I, II, III, and IV as per IEC1010 standards.
Step-by-step guide for measuring AC and DC voltages accurately with the multimeter.
Instructions for performing AC and DC current measurements using the meter.
Procedures for measuring electrical resistance using the multimeter.
How to perform continuity tests to check for electrical paths.
Steps for testing diodes using the multimeter's diode test function.
Explanation of how to use auto-ranging and manual range selection modes.
How to activate and use the MAX mode to capture peak readings.
Instructions on how to turn on and off the multimeter's display backlight.
How to use the HOLD function to freeze a measurement on the display.
Information about the auto power-off feature and how to wake the meter.
Guide for safely replacing the battery and fuses in the multimeter.
To Next Page