2 LCR200-EU-EN V1.5
11/13
Introduction
Congratulations on your purchase of Extech's Model LCR200 LCR meter. This meter will
accurately measure capacitors, inductors and resistors using the test frequencies of 100Hz, 120Hz
1 kHz, 10 kHz and 100 kHz. The dual display will simultaneously display the associated quality
factor, dissipation or phase angle value using a series or parallel equivalent circuit.
This meter is shipped fully tested and calibrated and, with proper use, will provide years of reliable
service.
Features
* 19,999/1,999 count dual LCD display.
* Auto LCR smart check and measurement.
* Serial/Parallel modes are selectable.
* Ls/Lp/Cs/Cp
wit
h D/Q/RP/ESR parameters.
* DC Resistance.
* Five test freque
ncies are available: 100Hz/120Hz/1kHz/10kHz/100kHz.
*
Test AC signal level : 600mV rms typically
.
* Test range :
( ex. F = 1 KHz )
L : 0.00uH to 2000.0H
C : 0.0pF to 2.000 mF
R : 0.000 to 200.0 M
* Multi-level battery detector.
* LCD with green backlight.
To Next Page
Loading...
