Need help?Do you have a question about the Extech Instruments EC600 and is the answer not in the manual?
General| Power Supply | 9V Battery |
|---|---|
| Type | Water Quality Meter |
| Temperature | 32 to 122°F (0 to 50°C) |
| Resolution | 0.1 µS/cm, 1 µS/cm, 0.01 mS/cm (Conductivity); 1 ppm, 10 ppm (TDS); 0.1°C/°F (Temperature) |
| Accuracy | ±2% FS (Conductivity); ±2% FS (TDS); ±0.5°C/±1°F (Temperature) |
| Temperature Compensation | Automatic |
| Display | LCD |
Instructions on how to store, recall, and clear logged measurement data from the meter's memory.
Detailed procedure for performing a three-point calibration for the pH meter using standard buffer solutions.
Guidance on performing one or two-point pH calibrations when the expected measurement range is known.
Details common error messages (ERR-1, ERR-2) and general troubleshooting steps for pH measurements.
Guidelines on how often to calibrate and specific situations requiring recalibration for accurate pH readings.
Instructions on proper handling, cleaning, soaking, and storage of the pH electrode to ensure longevity and accuracy.
Procedure for calibrating the conductivity meter using standard solutions.
Steps to measure conductivity, TDS, salinity, or resistivity of a sample solution.
Information on calibration solution series, one-point calibration, and electrode constant (K=1 cm⁻¹).
Instructions for keeping the conductivity electrode clean and maintaining the meter's performance.
Guidance on replacing electrodes and resetting the meter to factory defaults for unusual operation.
Details the measuring range, resolution, accuracy, input current, impedance, stability, and compensation range for pH measurements.
Details the measuring range, resolution, and accuracy for mV measurements.
Details measuring ranges, TDS, salinity, resistivity, resolution, accuracy, electrode constant, and temperature compensation for conductivity.
To Next Page