EC600 V2.0 4/10
2
Introduction
Congratulations on your purchase of the Extech Conductivity / pH meter. For best
results, please read the entire manual before use.
The EC600 meter measures Conductivity, pH, and temperature parameters.
Conductivity measurements also yield TDS (total dissolved solids), Salinity, and
Resistivity readings.
The built-in microprocessor provides automatic calibration, automatic temperature
compensation, data storage, and self-diagnostics. The meter can recognize up to 13
types of pH standard buffer solutions and 8 types of Conductivity standards.
The meter’s digital filter improves measurement speed and accuracy.
Two special modes (for distilled water and distilled water mixed with ammonia) are
provided.
The meter offers a backlit LCD display and is dust-proof and water-proof, meeting the
IP57 rating
This meter is shipped fully tested and calibrated and, with proper use, will provide years
of reliable service.
Supplied Equipment List
• EC6000 Meter
• Conductivity and pH Electrodes
• Standard pH buffer solutions (4.00pH, 7.00pH, and 10.01pH) / 50ml
• Standard Conductivity solution (1413µS/cm) / 50ml
• Screwdriver (for removing battery compartment)
• Batteries (2 x ’AA’ 1.5V)
• User’s Guide
• Carrying Case
www.burntec.comwww.burntec.com
To Next Page
Loading...
Need help?
General
