MN25 Version 2.2 Aug 2003
6
Display 3 ½ digit, 2000 count LCD, 0.5” digits
Overrange indication “1” is displayed
Diode Test Test current of 1mA maximum, open
circuit voltage 2.8V DC typical
Continuity Check Audible signal will sound if the
resistance is less than approximately
30Ω
Battery Test current 9V (6mA); 1.5V (100mA)
Input Impedance >1MΩ
ACV Bandwidth 45Hz to 450Hz
DCA voltage drop 200mV
Polarity Automatic (no indication for positive
polarity); Minus (-) sign for negative
polarity.
Measurement Rate 2 times per second, nominal
Low Battery Indication ‘BAT’ is displayed if battery voltage
drops below operating voltage
Battery 9 Volt Battery
Fuses mA, µA ranges; 0.2A/250V fast blow
A range; 10A/250V fast blow
Operating Temperature 41ºF to 104ºF (5ºC to 40ºC)
Storage Temperature -4
o
F to 140
o
F (-20
o
C to 60
o
C)
Operating Humidity Max 80% up to 87ºF (31ºC) decreasing
linearly to 50% at 104ºF (40ºC)
Storage Humidity < 80%
Operating Altitude 7000ft. (2000) meters maximum.
Weight 9.17 oz. (260g).
Size 4.78 x 2.38 x 1.57” (121.5 x 60.6 x
40mm)
Safety For indoor use and in accordance with
Overvoltage Category II, Pollution
Degree 2. Category II includes local
level, appliance, portable equipment,
etc., with transient overvoltages less
than Overvoltage Category III.
To Next Page
Loading...
Need help?
General
