To Next Page

To Previous Page

6 TM500-EU-EN v1.1 12/13

SettheTemperatureUnitsofMeasure(°Cor°F)

1. Accessthet‐CFparameter.

2. Usethearrowbuttonstoselect°Cor°F.PressENTERtoconfirmsetting.

3. PresstheENTERbutton toexittotheSetupmode.PressESCtoexitsetupmode.

SettingtheDataloggerSamplingTime(Rate)

1. AccesstheSP‐tparameter.

2. Usethearrowbuttonstoselectthedesiredsamplingrate.Theavailablesettingsare:

0,1,2,

5,10,30,60,120,300,600, 1800,and3600seconds .Use‘0’formanuallogg ingmode.A

samplingrate>1secondisrecommended.



PresstheENTERbuttontoconf irmtheentry.



4. PresstheENTERbutton toexittotheSetupmode.PressESCtoexitsetupmode.

SDCardFORMATTING

1. AccesstheSdFparameter.

2. UsethearrowbuttonstoselectYEStoformatthecard(selectNOtoabort).Notethatall

dataonthecardwillbelostifformattingisattempted.

3. PressENTERtoconfirmselection.

4. PressENTERagaintore‐confirm.

5. PresstheENTERbuttontoexi

ttotheSetupmode.

PressESCtoexitsetupmode.

Note:alwaysformatanewSDmemorycardbeforeuse.

netzerotools.com

Extech Instruments TM500-NIST User Manual

Questions and Answers: