CHAPTER 12
PAGE 10
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
4 Unscrew engine oil drain plug and allow the oil to drain
thoroughly.
5 Using a clean rag or paper towel, wipe drain plug clean
and area on engine around oil drain.
6 Reinstall drain plug and safety wire.
7 Remove and inspected oil filter for metal particles and
install new oil filter in accordance with Lycoming Op-
erating Manual.
8 Replenish engine oil as per Chapter 12-10-04.
9 Reinstall and secure engine cowlings.
12-10-06 Replenishment of Brake Fluid
In order to assure proper brake action, it is necessary to have
positive transfer of hydraulic pressure through the system.
Any air trapped in the system must be removed. Follow the
procedure described below using a bleed tank (1, Figure 1):
1 Remove engine cowlings as per Chapter 51-00-01.
2 Remove fluid reservoir filler plug and screw a clear
plastic hose with appropirate fitting into the filler hole
at the top of the fluid reservoir.
3 Remove bleeder fitting cap (3) of the wheel brake as-
sembly (2).
4 Be certain that the bleeding equipment to be used is
absolutely clean and is filled with brake fluid that con-
forms to Specification MIL-H-5606, (refer to Chapter
05-20 Lubrication Charts) and is uncontaminated.
5 Maintain an adequate supply of fluid during the entire
operation. A low fluid supply will allow air to be drawn
into the system.
Oil Change
REPLENISHING
To Next Page
Loading...
