Extra 200 - Page 112

CHAPTER 12
PAGE 11
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
Replenishment of Brake Fluid
Figure 1
6 Ensure master cylinders are in neutral position.
7 Attach the connector hose (4) to the bleeder fitting.
8 Turn the bleeder fitting 1/2 rotation to the left for open-
ing.
9 Slowly pump clean hydraulic fluid in the system. Bleed-
ing should continue until no more air bubbles are ex-
pelled from the system (observe the immersed end of
the clear hose), and a firm brake pedal is obtained (fill
each side of the system with min. 0.33 ltr (0.1 U.S
Gallons) for complete change).
10 Fill the fluid reservoir up to full reservoir capacity.
11 Reinstall fluid reservoir filler plug.
12 Close bleeder fitting.
13 Disconnect the connector hose.
14 Reinstall bleeder fitting cap.
15 Check the brake operation.
Replenishment of Brake Fluid
REPLENISHING