Extra 200 - Page 192

CHAPTER 28
PAGE 17
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
28-21-00 MAINTENANCE PRACTICES
28-21-01 Fuel Selector Valve Removal/Installation
1 Drain the fuel system per Chapter 12-10-02.
2 Disconnect the fuel lines on the selector valve.
3 Remove the control rod attachment bolts (5, Figure 8).
4 Remove the selector valve attachment bolts (2).
5 Remove the selector valve (1).
6 Install in reverse sequence of removal. Use LOCTITE
when installing the selector valve attachment bolts.
28-21-02 Fuel Selector Valve Control Rod
Removal/Installation
1 Remove the rear control rod connection bolt (11, Fig-
ure 8).
2 Remove the rear control rod (12) to the rear.
3 Loosen the bolt of the adjusting ring (8).
4 Remove the front control rod connection bolt (7).
5 Remove the middle control rod (10), the adjusting ring
(8) and the spring (9) to the rear.
6 Remove the control rod attachment bolts (5).
7 Remove the front control rod (6) .
8 Install in reverse sequence of removal. Consider that
the position of the adjusting ring shall give the spring
enough tension to move the control rod into the fore-
most position after having tied back.