EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
CHAPTER 33
PAGE 4
PAGE DATE: 1. July 1996
33-40-00 EXTERIOR
A single strobe light system is installed as standard in the
Extra 200 consisting of a strobe light positioned at the top
of the main fuselage cover just behind the canopy and a
power supply which is mounted in the fuselage behind the
back seat at three points.
From the rear instrument panel the wiring follows the
respective steel tubes of the fuselage.
As an option the Extra 200 is equipped with a dual strobe
light combined with a navigation light system. The lighting
units (1, Figure 1) installed at the wing tips incorporate the
red or green navigation lights on the forward section, a
strobe light in the center and a clear tail position light on the
aft section. They are mounted at the wing tip panel (2). The
strobe light power supplies (10) are mounted on special
attachment plates (11) inside the wing.
The wiring is routed through an aluminium tube inside the
wing and along the left resp. right upper longeron to the rear
instrument panel. Ground bonding leads are installed be-
tween the fuselage, the aluminium tube, the pitot tube
mount ( LH wing only), the strobe light power supply and
the wing tip panels.
The switches and circuit breakers are located at the rear
instrument panel.
To Next Page
Loading...
