CHAPTER 51
PAGE 33
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
Paint Removal
Disassemble components to the level required for repaint-
ing, then proceed as follows.
W A R N I N G Stripping solvents can be toxic and volatile. Use only
in well ventilated areas. Avoid physical contact with
solvent and do not inhale vapors. Keep solvent
containers covered when not in use.
C A U T I O N Before stripping parts, remove all fittings, O-rings,
nuts, bolts, washers, pistons, bearing cups, etc. Parts
must be totally immersed in solvent, to maximize
cleaning.
1 Degrease part per degreasing paragraph.
2 Totally immerse part in paint removing solvent. Portions
not totally covered by solvent will begin to corrode.
N O T E Stripping agents are commercially available for remov-
ing topcoat and primer. Follow manufacturer's recom-
mendations for use and disposal of stripping solutions.
3 Remove part from solvent and rinse thoroughly with
water heated to 160° to 180°F (71° to 82° C). Flush
solvent from all cavities and threaded holes where en-
trapment might occur
4 Thoroughly dry part with filtered, dry compressed air.
5 Where applicable refer to inspections procedures given
in the respective chapters for specific parts to locate
possible defects.
N O T E Refinishing should be completed as soon as possible;
unprotected parts will begin to corrode.
Aluminium and Steel Components Refinishing
REP
AIRS
To Next Page
Loading...
