CHAPTER 51
PAGE 34
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
Repainting
Paint all surfaces except those which are subjected to friction
(bearing surfaces, anchor bolt bores, etc.). Proceed as
follows:
1 Parts to be repainted should be cleaned and stripped per
instruction in degreasing and paint removal paragraphs.
2 Aluminium parts should have a protective barrier be-
tween the topcoat and base metal. It is recommended
they be treated with solutions listed in Chapter 51-30.
3 Apply solution liberally and evenly. Allows it to set from
1 to 5 minutes. The solution must completely wet the
surface and overlap onto the adjoining anodize.
4 Remove excess coating by flushing with clean water.
5 Paints parts with one coat of wash primer. Allow to dry
thoroughly.
6 Paint parts with one coat of lacquer listed in Chapter
51-30. Allow to dry thoroughly before reassembly.
Aluminium and Steel Components Refinishing
REP
AIRS
To Next Page
Loading...
