3. Locate the composite aileron control horn, aileron pushrod with z-bend and ez-
connector. Remove the covering over the mounting hole for the control horn with
your #11 blade. Glue the control horn in place with medium CA. Electronically
center your servo and mount the ez-connector to the servo arm. Place the z-bend
in the aileron control horn and the other end of the wire into the hole in the ez-
connector. Center the aileron and tighten the screw in the top of the ez-connector
to retain the aileron pushrod wire. See picture.
4. Repeat for the other wing.
That’s it! You are done with the wings!
4
To Next Page
Loading...
