Need help?Do you have a question about the Extreme Flight Legacy Aviation Turbo Bushmaster and is the answer not in the manual?
General| Brand | Extreme Flight |
|---|---|
| Model | Legacy Aviation Turbo Bushmaster |
| Category | Toy |
| Language | English |
Critical safety warnings regarding product misuse, potential injury, and liability.
Details the kit warranty period and limitations, including flutter.
Scuff, prepare, and glue control horns into wing panels for ailerons and flaps.
Prepare and install hinges using epoxy, ensuring free movement and proper alignment.
Attach servo extensions, install servos and arms, and connect pushrods to control horns.
Fit, mark, and glue wing fences to the wing panels.
Slice rubber tubing lengthwise and place around landing gear fairings.
Attach landing gear to fuselage and mount the wheels using axles and hardware.
Glue control horn to stabilizer and hinge the elevator section using the same technique as wing.
Center and align the horizontal stabilizer with main wings, then glue in place.
Locate and attach fences for the horizontal stab, ensuring alignment with the vertical stab.
Attach wheel to axle using collar, then install mounting bracket and tiller arm.
Insert pushrod, clear covering, and secure tailwheel assembly to the fuselage.
Hinge the rudder, test fit, and install rudder control horns using epoxy.
Insert stab tube, secure stab to fuselage, and install the vertical stab wedge.
Mount rudder servo, connect EZ-connector, slide pushrod, and assemble pull-pull cables.
Glue or screw the windscreen into place, trimming as needed and securing with tape.
Secure prop adapter, collar, and X mount to the motor using thread lock.
Attach motor to firewall and mount ESC to the bottom of the motor box.
Glue exhaust stacks, mark and drill for cowl mounting, then attach the cowl with screws.
To Next Page