4 Select an LED Status. Valid values are:
Table 45: LED Operational Modes
LED Mode Information Displayed
O Displays fault patterns only. LEDs do not light when the AP is fault free
and the discovery is complete.
Normal Identifies the AP status during the registration process during power on
and boot process.
Identify All LEDs blink simultaneously approximately two to four times every
second.
5 Configure the following parameters:
Note
The AP must be part of a device group before the radio settings and the Professional
Install button are displayed. To add an AP to a device group, see Adding APs on page 107.
Table 46: Radio Properties
Field Description
Use RF Management Policy Indicates if settings from the RF Management policy that is
associated with the device group are used. If you select Yes, links to
the RF Management Policy and the site are present. If you select No,
the radio settings are displayed. You can modify radio setting from
here.
Channel Width Determines the channel width for the radio. Valid values are:
•
20 MHz
•
40 MHz
•
80 MHz (supported on 5GHz only 802.11ac and 802.11ax)
•
160 MHz (supported on 5GHz only 802.11ax)
•
Automatic – Channel width is calculated automatically. This is
the default value.
Request New Channel Specifies the primary channel of the wireless AP. Select Auto to
request ACS to search for a channel using a channel selection
algorithm. Depending on the licensed regulatory domain, channels
may be restricted. ACS in the 2.4 GHz radio band with 40 MHz
channels is not recommended due to severe co-channel
interference.
Max Tx Power Determines the maximum power level that can be used by the radio
in dBm. The values are governed by compliance requirements based
on the country, radio, and antenna selected, and will vary by AP.
6 Select Save.
Related Links
Advanced AP Settings on page 110
Professional Install Settings on page 110
Configure
ExtremeCloud Appliance User Guide for version 4.36.03 109
To Next Page
Loading...
