Extreme Networks ExtremeCloud Appliance Series - AP Adoption Rules

•
Select a group to view or edit.
•
Click Add to add a new group.
Related Links
VLAN Group Settings on page 142
VLAN Group Settings
To create a VLAN Group:
1 Go to Configure > Policy > VLAN Groups.
2 Click Add.
3 Configure the following parameters:
Name Group name.
Mode Only Bridged@AC topologies using AP39xx access points are supported.
VLAN ID ID for the VLAN Group
VLANs List of configured VLANs that can be added to the group. Select a VLAN from the list and click the
plus sign to add the VLAN to the group.
4 Click Save.
Related Links
VLAN Groups on page 141
Configuring Rates
You can set a data transfer rate for a policy.
To configure rates:
1 Go to Configure > Policy > Rates.
2 Select Add or select an existing rate from the list.
3 Configure the following parameters:
Average Rate (CIR)
Specify the rate at which the network will support data transfer under normal operations.
It is measured in kilo-bits per second (kbps).
4 Select Save.
AP Adoption Rules
The AP adoption feature simplifies the deployment of a large number of APs. A set of rules defines the
device group assignment for new APs, when they register for the first time. Without adoption rules
defined, you must manually select each AP for inclusion in a device group.
Note
Without Adoption Rules, based on the AP license domain and model number, when a device
group configuration matches this criteria, ExtremeCloud Appliance prompts you to add the
APs, but you must manually select each AP for inclusion.
Configure
ExtremeCloud Appliance User Guide for version 4.36.03 142