Summit24e3 Switch Quick Reference Guide 19
enable iproute sharing Enables load sharing if multiple routes to the same destination
are available. Only paths with the same lowest cost are shared.
The default setting is disabled.
enable irdp {vlan <name>} Enables the generation of ICMP router advertisement messages
on one or all VLANs. The default setting is enabled.
enable loopback-mode vlan [<name> | all] Enables a loopback mode on an interface. If loopback is
enabled, the router interface remains in the UP state, even if no
ports are defined in the VLAN. As a result, the subnet is always
advertised as one of the available routes.
rtlookup [<ipaddress> | <hostname>] Performs a look-up in the route table to determine the best route
to reach an IP address.
show iparp {<ipaddress | vlan <name> |
permanent}
Displays the IP Address Resolution Protocol (ARP) table. You
can filter the display by IP address, VLAN, or permanent entries.
show ipconfig {vlan <name>} Displays configuration information for one or all VLANs.
show ipfdb {<ipaddress> <netmask> | vlan
<name> }
Displays the contents of the IP forwarding database (FDB) table.
If no option is specified, all IP FDB entries are displayed.
show iproute {priority | vlan <vlan> |
permanent | <ipaddress> <netmask> |
route-map | origin [direct | blackhole | bootp |
icmp} {sorted}
Displays the contents of the IP routing table, the route origin
priority, or the route origin route map.
show ipstats {vlan <name>} Displays IP statistics for the CPU of the system.
show udp-profile {<profile_name>} Displays the profile names, input rules of UDP port, destination
IP address, or VLAN and the source VLANs to which the profile
is applied.
unconfig icmp Resets all ICMP settings to the default values.
unconfig irdp Resets all router advertisement settings to the default values.
unconfig udp-profile vlan [<name> | all] Removes the UDP-forwarding profile configuration for one or all
VLANs.
Command Description
To Next Page
Loading...
