Summit24e3 Switch Quick Reference Guide 21
enable rip Enables RIP. The default setting is disabled.
enable rip aggregation Enables aggregation of subnet information on interfaces
configured to send RIP v2 or RIP v2-compatible traffic. The
switch summarizes subnet routes to the nearest class network
route. The following rules apply when using RIP aggregation:
■ Subnet routes are aggregated to the nearest class network
route when crossing a class boundary.
■ Within a class boundary, no routes are aggregated.
■ If aggregation is enabled, the behavior is the same as in RIP
v1.
■ If aggregation is disabled, subnet routes are never
aggregated, even when crossing a class boundary.
The default setting is disabled.
enable rip export [static | direct] metric
<metric> {tag <number>}
Enables RIP to redistribute routes from other routing functions.
Specify one of the following:
■ static — Static routes
■ direct — Interface routes (only interfaces that have IP
forwarding enabled are exported)
The metric range is 0-15. If set to 0, RIP uses the route metric
obtained from the route origin.
enable rip originate-default {always} cost
<metric> {tag <number>}
Configures a default route to be advertised by RIP if no other
default route is advertised. If always is specified, RIP always
advertises the default route to its neighbors. If always is not
specified, RIP adds a default route if there is a reachable default
route in the route table.
enable rip poisonreverse Enables the split horizon with poison-reverse algorithm for RIP.
The default setting is enabled. If you enable poison reverse and
split horizon, poison reverse takes precedence.
enable rip splithorizon Enables the split horizon algorithm for RIP. Default setting is
enabled.
enable rip triggerupdates Enables triggered updates. Triggered updates are a mechanism
for immediately notifying a router’s neighbors when the router
adds or deletes routes, or changes the metric of a route. The
default setting is enabled.
show rip {detail} Displays RIP configuration and statistics for all VLANs.
show rip stat {detail} Displays RIP-specific statistics for all VLANs.
show rip stat vlan <name> Displays RIP-specific statistics for a VLAN.
show rip vlan <name> Displays RIP configuration and statistics for a VLAN.
unconfig rip {vlan <name>} Resets all RIP parameters to match the default VLAN. Does not
change the enable/disable state of the RIP settings. If no VLAN
is specified, all VLANs are reset.
Command Description
To Next Page
Loading...
