Extreme Networks Summit Summit24 - Page 7

Summit24e3 Switch Quick Reference Guide 7
Configuring Ports on a Switch Commands
Command Description
config ports <portlist> auto off {speed [10 |
100 | 1000]} duplex [half | full]
Changes the configuration of a group of ports. Specify the
following:
■ auto off — The port will not autonegotiate the settings.
■ speed — The speed of the port (for 10/100 Mbps or
100/1000 Mbps ports only).
■ duplex — The duplex setting (half- or full-duplex).
config ports <portlist> auto on Enables autonegotiation for the particular port type; 802.3u for
10/100 Mbps ports or 802.3z for Gigabit Ethernet ports.
config ports <portlist> display-string <string> Configures a user-defined string for a port. The string is
displayed in certain show commands (for example, show port
all info). The string can be up to 16 characters.
config sharing address-based [mac_source |
mac_destination | mac_source_destination |
ip_source | ip_destination |
ip_source_destination]
Configures the part of the packet examined by the switch when
selecting the egress port for transmitting load-sharing data. This
feature is available using the address-based load-sharing
algorithm, only.
disable edp ports <portlist> Disable EDP on one or more ports.
disable ports <portlist Disables a port. Even when disabled, the link is available for
diagnostic purposes.
disable ports <portlist> Disables a port. Even when disabled, the link is available for
diagnostic purposes.
disable sharing <port> Disables a load-sharing group of ports.
enable edp ports <portlist> Enables the generation and processing of EDP messages on
one or more ports. The default setting is enabled.
enable ports <portlist> Enables a port.
enable sharing <port> grouping <portlist>
{address-based}
Defines a load-sharing group of ports. The ports specified in
<portlist> are grouped to the master port. The optional
load-sharing algorithm, address-based, uses addressing
information as criteria for egress port selection.
restart ports <portlist> Resets autonegotiation for one or more ports by resetting the
physical link.
show edp Displays EDP information.
show ports {<portlist>} collisions Displays real-time collision statistics.
show ports {<portlist>} configuration Displays the port configuration.
show ports {<portlist>} info {detail} Displays detailed system-related information.
show ports {<portlist>} packet Displays a histogram of packet statistics.
show ports {<portlist>} rxerrors Displays real-time receive error statistics.
show ports {<portlist>} stats Displays real-time port statistics.
show ports {<portlist>} txerrors Displays real-time transmit error statistics.