6 Summit24e3 Switch Quick Reference Guide
enable radius Enables the RADIUS client. When enabled, all CLI logins are
sent to the RADIUS servers for authentication. When used with a
RADIUS server that supports ExtremeWare CLI authorization,
each CLI command is sent to the RADIUS server for
authentication before it is executed.
enable radius-accounting Enables RADIUS accounting. The RADIUS client must also be
enabled.
enable snmp access Turns on SNMP support for the switch.
enable snmp traps Turns on SNMP trap support.
enable sntp-client Enables Simple Network Time Protocol (SNTP) client functions.
enable tacacs Enables TACACS+. Once enabled, all CLI logins are sent to one
of the two TACACS+ server for login name authentication and
accounting.
enable tacacs-accounting Enables TACACS+ accounting. If accounting is use, the
TACACS+ client must also be enabled.
enable tacacs-authorization Enables CLI command authorization. When enabled, each
command is transmitted to the remote TACACS+ server for
authorization before the command is executed.
show radius Displays the current RADIUS client configuration and statistics.
show sntp-client Displays configuration and statistics for the SNTP client.
show tacacs Displays the current TACACS+ configuration and statistics.
show tacacs-accounting Displays the current TACACS+ accounting client configuration
and statistics.
telnet [<ipaddress> | <hostname>]
{<port_number>}
Enables a Telnet session on the switch. Up to eight active Telnet
sessions can access the switch concurrently. You can Telnet to
a switch by entering the IP address of the switch or the
hostname of the switch. The Telnet session defaults to port 23.
unconfig management Restores default values to all SNMP-related entries.
unconfig tacacs {server [primary | secondary]} Unconfigures the TACACS+ client configuration.
unconfig tacacs-accounting {server [primary |
secondary]}
Unconfigures the TACACS+ accounting client configuration.
Command Description
To Next Page
Loading...
