Summit WM Maintenance Guide, Software Version 5.3 105
To enable SNMP Parameters:
1 From the main menu, click Summit WM Controller. The Summit WM Controller page is displayed.
2 In the left pane, click SNMP. The Simple Network Management Protocol page is displayed.
3 Type the following:
● Contact Name – Specifies the name of SNMP administrator.
● Location – Specifies the location of the SNMP administration machine.
● Read Community Name – Specifies the community name for users with read privileges.
● Read/Write Community Name – Specifies the community name for users with read and write
privileges.
● SNMP Trap Port – Specifies the destination port for SNMP traps. The industry standard is 162. If
left blank, no traps are generated.
● Forward Traps – Specifies the security level of the traps to be forwarded. From the drop-down
list, click Informational, Minor, Major, or Critical.
● Manager A – Specifies the IP address of the specific machine on the network where the SNMP
traps are monitored.
● Manager B – Specifies the IP address of a second machine on the network where the SNMP traps
are monitored, if Manager A is not available.
NOTE
For security purposes, it is recommended that you immediately change the Read Community Name (public) and
the Read/Write Community Name (private) to names that are less obvious and more secure.
To Next Page
Loading...
