Extreme Networks Summit WM - Resetting the Altitude 450;451 (802.11 N) AP to Its Factory Default Settings

Summit WM Maintenance Guide, Software Version 5.3 85
NOTE
The reset button is located below the housing cover beside the sockets for the external antennas. To access the reset
button, you must remove the housing cover. For more information, see the Outdoor AP Installation Guide.
Resetting the Altitude 450/451 (802.11n) AP to its factory
default settings
You can set the Altitude 802.11n AP to its factory default settings by pressing and holding the reset
button for approximately four seconds.
Figure 9: Position of the reset button in the Altitude 802.11n AP
NOTE
If you press the reset button and do not hold it over four seconds, the Altitude 802.11n AP will merely reboot, and
not reset to its factory defaults.
Reset Button