Summit WM Maintenance Guide, Software Version 5.3 73
5 Using the Console Port
This chapter describes how to use the console ports in the following models of the Summit WM
Controllers:
● Summit WM200/2000 Controller
● Summit WM20 Controller
● Summit WM100/1000 Controller
Using the Console Port in the Summit WM200/2000
Controller
In order to get into the Rescue mode in the Summit WM200/2000 Controller, you must connect your
laptop to controller’s Console Port via the Null Modem DB9 F- F (Female to Female) Cable.
The following illustration shows the cable connection between a laptop and the Summit WM200/2000
Controller.
Figure 4: Connection between the Summit WM200/2000 Controller and laptop with serial port.
If your laptop has a USB port instead of a serial port, you must use the USB 2.0 To RS232 Serial Adapter
to connect the Null Model DB9 F-F Cable to the laptop.
The following illustration shows the cable connection between the laptop with a USB port and the
Summit WM200/2000 Controller.
Console Port
Serial Port
To Next Page
Loading...
