Upgrading the Summit WM Controller from V5R3 to V5R3 General Patch (GP)
Summit WM Maintenance Guide, Software Version 5.342
3 Select Remote. The ftp server boxes are displayed.
4 Type the following:
● FTP Server – The IP address of the FTP server to retrieve the image file from.
● User ID – The user ID used to log in to the FTP server.
● Password – The corresponding password for the user ID.
● Confirm – The corresponding password for the user ID, to confirm it was typed correctly.
● Directory – The directory on the server in which the image file that is to be retrieved is stored.
● Filename – The name of the image file to retrieve.
5 If applicable, backup the current system image:
● To save the backup image locally, select the Flash option, and then type a file name for the
backup image in the Filename box. The filename must end with the .tgz extension.
● To save the backup image on a remote FTP server, select the Remote option, and then type the
following:
■ FTP Server – The IP of the FTP server that will store the image file.
■ User ID – The user ID used to log in to the FTP server.
■ Password – The corresponding password for the user ID.
■ Confirm – The corresponding password for the user ID, to confirm it was typed correctly.
■ Directory – The directory on the server in which the image file is to be stored.
■ Filename – The name of the image file. The filename must end with the .tgz extension.
6 If applicable, clear the Backup system image to option if you do not want to save a backup image of
your current system.
To Next Page
Loading...
