Summit WM Maintenance Guide, Software Version 5.3 75
3 With a normal USB (male A/B) cable, connect the B end to the Summit WM20 Controller and the A
end to the laptop. The driver recognizes the connection and installs a serial device (Com #).
To determine the actual number assigned to the device, navigate to Control Panel > System >
Hardware > Device Manager > Ports (COM & LPT).
4 Using a terminal program of choice (for example, Hyperterm) establish a connection to the Summit
WM20 Controller using the corresponding COM device.
The connection settings are 9600 8N1 no flow (9600 bps, 8 bits, no parity, 1 stop bit, no flow).
To install the driver:
NOTE
The following procedure is applicable for installing CP210x VCP driver specific to Windows 2000/XP/2003
Server/Vista.
a Double-click on the .exe file. The setup wizard is launched.
b Click Next. The License Agreement window opens.
c Select the I accept the terms of the license agreement radio button, and then click Next. The
Destination Location window opens.
To Next Page
Loading...
