Extreme Networks Summit X670-G2 Series User Manual

Canada Warnings
Summit X670-G2 Series Switches Installation Note
7
GBIC, SFP (Mini-GBIC), QSFP+, XENPAK, and XFP Regulatory
Compliance
Extreme Networks pluggable optical modules and direct-attach cables meet the following regulatory
requirements:
● Class 1 or Class 1M Laser Product
● EN60825-1:2007 2nd Ed. or later, European standard
● FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
● Application of CE Mark in accordance with 2004/108/EEC EMC Directive and the 2006/95/EC Low
Voltage Directives
● UL and/or CSA registered component for North America
● 47 CFR Part 15, Class A when installed into Extreme products
Canada Warnings
WARNING!
Disconnect all power supply cords before servicing.
Débranchez tous les cordons d'alimentation avant l'entretien.
WARNING!
A dedicated Listed circuit breaker rated at 20A is to be used for each power supply connection.
Un disjoncteurListed dédié évalué à 20A doit être utilisée pour chaque connexion d'alimentation .
WARNING!
Extreme Networks power supplies do not have switches for turning the unit on and off. Disconnect all
power cords to remove power from the device. Make sure that these connections are easily accessible.
Extreme Networks alimentations n'ont pas de contact pour mettre l'appareil sous et hors tension . Débranchez tous
les cordons d'alimentation pour couper l'alimentation de l'appareil. Assurez-vous que ces connexions sont
facilement accessibles.
NOTE
The site must have secured, enclosed, and restricted-access, ensuring that only trained and qualified
service personnel have access to the equipment.
Le site doit avoir obtenu , clos , et à accès restreint , assurant que seul un personnel formé et qualifié avoir accès à
l'équipement.

Extreme Networks Summit X670-G2 Series Specifications

General

Brand	Extreme Networks
Model	Summit X670-G2 Series
Category	Switch
Language	English