AVT 200HD Tuner • Remote Configuration and Control 54
Command
ASCII Command
(Host to Tuner)
Response
(Tuner to Host)
Additional Description
Other Settings (continued)
Show HDCP for output display
E
O HDCP
} X1!]
In verbose mode:
HDCPO
X1!]
Show HDCP compliance
X1!
for
the display. For
X1!
:
0 = output connected with
encrypted input but not
HDCP compliant
1 = output connected with
encrypted input and HDCP
compliant
2 = No output connected
3 = Output connected, input
not encrypted or not
connected, output HDCP
status unknown
Executive Mode (Front Panel Lockout)
Enable executive mode 1
1X
Exe1
]
Select executive mode 1: block
all front panel access (IR remote
control is available).
Enable executive mode 2
2X
Exe2
]
Select executive mode 2: block
all front panel access except
volume control (IR remote control
is available).
Enable executive mode 3
3X
Exe3
]
Select executive mode 3: block IR
remote control access only.
Disable executive mode
0X
Exe0
]
Turn executive mode off.
View executive mode status
X
X1@]
View current executive mode.
Information Requests
General information
I
Tvtm
X1)
•Tvct
X!
.
X@
•Sig
X3!]
Show the currently selected
tuning mode (
X1)
), channel
(
X!
.
X@
) and signal strength level
(
X3!
).
For
X1)
:
0 = tune mode.
1 = preset mode.
X!
= 1–135;
X@
= 1–99
X3!
= 1–100%
Example:
I
Tvtm1 Tvct004.01 Sig042
]
The AVT is in tune mode;
channel 4.1 is selected;
signal strength is 42%.
Query rmware version
Q n.nn
In verbose mode:
Ver1*n.nn
]
Show the current firmware
version to two decimal places.
Query part number
N
60-770-01
]
In verbose mode:
Pno 60-770-01
]
Show the unit part number.
Internal temperature
E
20STAT
} X1#]
In verbose mode:
Stat
X1#]
Show the internal temperature in
degrees Fahrenheit.
X1#
= +nnn.nn
To Next Page
Loading...
