Ezviz HB8 - 2. Installation Location

6
6. In the EZVIZ app, tap Storage Status in the Device Settings interface to check the SD card status.
7. If the micro SD card status displays as Uninitialized, tap to initialize it.
The status will then change to Normal and then videos can be stored.
2� Installation Location
Choosealocationwithaclear,unblockedeldofviewandwithagoodwirelesssignaltothecamera.Please
keep the following tips in mind.
• Make sure the wall is strong enough to withstand three times the weight of the camera.
• Recommended installation height: 10.0 ft (3 m).
• Detection distance range: 6.5-29.53 ft (2-9m).
• Makesurethatside-to-sidetrafccrossescamera’seldofview.Thecamera’smotionsensorismuchmore
sensitivetoside-to-sidemovementacrossitseldofviewthantomovementdirectlytowardorawayfromthe
camera.
Limited by PIR detection technology, the camera may fail to detect motion when environment temperature is close to
human body temperature or someone approaches the PIR sensor vertically.
• It is recommended to set detection sensitivity on the EZVIZ app when selecting location. Thus you can verify
if motion can be detected in the camera’s placement and adjust the sensitivity based on the size and distance
of detected object.
Important Notes on Reducing Too Many Alarms:
•Do not install the camera under strong light conditions, including sunshine, bright lamp lights, etc.
•
Donotplacethecameranearanyoutlets,includingtheairconditionervents,humidieroutlets,the
heat transfer vents of projectors, etc.
•Do not install the camera at places with strong wind.
•Do not install the camera in front of a mirror.
•
Keep the camera at least 1 meter away from any wireless devices, including Wi-Fi routers and phones
in order to avoid wireless interference.