F'real FRLB6 - Blender Maintenance Procedures; Daily Blender Maintenance Steps; Weekly Blender Maintenance Steps

4
1
Open the front door and perform a visual inspecon to
verify the surfaces are clean.
Wipe down the blender daily with a so cloth and soluon
or glass cleaner.
3
Wipe down the Cup Holder and underneath the Cup Holder
in the Drip Pan area with a damp cloth.
Cup Holder Drip Pan
Don’t spray soluon
directly onto the screens
Press upwards on the Flip-Up Door to clean o any product
build-up around the blending chamber rim and gasket.
Be careful not to
damage the gasket
Panels
Screens
Daily Blender Maintenance
4
2
1
Open front door and locate the seal from around the
chamber opening and follow the steps below:
Remove the seal
A. Clean seal with a damp cloth and rinse
B. Clean chamber opening rim, inside and out
C. Re-install the seal
D. Clean the Chamber Door
2
Weekly Blender Maintenance
Locate the cup sensors underneath the front door.
Use a damp cloth and wipe them down.
(10 total sensors)
A B
C D E