Need help?Do you have a question about the F'real FRLB6 and is the answer not in the manual?
Covers daily cleaning tasks for the blender, including visual inspection and surface wiping.
Details weekly cleaning procedures for seals, chamber openings, and cup sensors.
Instructions on how to navigate and access the blender's main menu interface.
Description of the different tabs and options available within the main menu.
Procedure for clearing error codes through the main menu system.
Troubleshooting for mix motor peak current limit exceeded.
Troubleshooting for position motor peak current limit exceeded.
Troubleshooting for pump motor peak current limit exceeded.
Troubleshooting for any blend routine time-out parameter exceeded.
Troubleshooting for the sanitize sequence timing out.
Troubleshooting for steamer heater temperature outside allowable range.
Troubleshooting for steamer heater temperature control errors.
Troubleshooting for scour heater temperature control errors.
Troubleshooting for mix motor FET destroyed error.
Troubleshooting for pump motor FET destroyed error.
Troubleshooting for chamber temperature sensor differential limit exceeded.
Troubleshooting for end-stop detection failure in calibration sequence.
Troubleshooting for chamber temperature being too low.
Troubleshooting for flip-up door misalignment at end of blend cycle.
Customer guidance for ensuring the cup lid is completely removed before blending.
Guidance for ensuring the front door is properly closed and latched.
Troubleshooting for the flip-up door opening at unexpected times.
Addressing obstructions that prevent the cup holder from moving freely.
Guidance on using the correct cup size for the blender.
Addressing issues where the product is not cold enough to blend.
Troubleshooting when the blender indicates it needs water to blend.
Guidance on removing obstructions from the underside of the blending chamber.
Addressing the error when a cup is left in the holder too long after blending.
Troubleshooting for problems with the front door not closing or opening correctly.
Diagnosing and fixing water leaks from the front door area.
Troubleshooting unusual grinding noises during the blending process.
Addressing blended beverages that are too thin or too thick.
Troubleshooting for problems with the cup placement and size sensor circuits.
General| Model | FRLB6 |
|---|---|
| Type | Blender |
| Voltage | 120V |
| Material | Stainless Steel |
| Color | Silver |
To Next Page