F.W. Bell 5200 Series - Section 3 Operating Instructions; Operator Safety Warnings

Section 3
Operating Instructions
OPERATOR SAFETY 1
This symbol appears on the instrument and probe. It
refers the operator to additional information contained in
this instruction manual, also identified by the same
symbol.
Be careful when operating the instrument near large
magnetic fields, as it may affect the battery by
shortening the lifespan or decreasing efficiency.
Do not allow the probe to come in contact with any
voltage source greater than 30 Vrms or 60 Vdc
Figure 3-1
Probe Electrical Warning
3-1
Figure 3-1
Probe Electrical Warning