F.W. Bell 5200 Series - SCPI Commands for Modes, Ranges, and Hold

MODE COMMANDS
DESCRIPTION
ZERO/RELATIVE COMMANDS
DESCRIPTION
:UNIT:FLUX:AC:GAUSs
Program ac gauss units
:SYSTem:AZERo
Initiates an automatic zero
operation
:UNIT:FLUX:AC:TESLa
Program ac tesla units
:SYSTem:ARELative:STATe
<n>
Program relative mode
:UNIT:FLUX:AC:AM
Program ac ampere per meter units
:SYSTem:ARELative:STATe?
Query relative mode setting
:UNIT:FLUX:DC:GAUSs
Program dc gauss mode
:UNIT:FLUX:DC:TESLa
Program dc tesla units
MEASUREMENT COMMANDS
DESCRIPTION
:UNIT:FLUX:DC:AM
Program dc ampere per meter units
:MEASure:FLUX?
Obtain flux density reading.
:UNIT:FLUX?
Query flux units setting
ANALOG OUTPUT
COMMANDS
DESCRIPTION
RANGE COMMANDS
DESCRIPTION
:SYSTem:OUT <n>
Enable / disable analog output
:SENSe:FLUX:RANGe:AUTO
Program auto range
:SENSe:FLUX:RANGe <n>
Program fixed range
:SENSe:FLUX:RANGe?
Query range setting
HOLD COMMANDS
DESCRIPTION
:SENSe:HOLD:STATe <n>
Program hold mode
:SENSe:HOLD:STATe?
Query hold mode setting
:SENSe:HOLD:RESet
Reset held value
Table 4-2
SCPI Commands
4-14