F.W. Bell 5200 Series - Hold Commands

HOLD COMMANDS
These commands select one of the HOLD modes or resets the presently held reading. See Section 3 for
more information.
:SENSe:HOLD:STATe <n>
Selects the HOLD function, where <n> is a single ASCII digit, as follows:
0 = All HOLD modes turned off.
1 = MIN HOLD on.
2 = MAX HOLD on.
3 = PEAK HOLD on.
:SENSe:HOLD:STATe?
Returns an ASCII digit representing the present HOLD mode setting, as follows:
0 = All HOLD modes turned off.
1 = MIN HOLD on.
2 = MAX HOLD on.
3 = PEAK HOLD on.
:SENSe:HOLD:RESet
This command resets the presently held reading.
4-19