18
=
=
ENGLISH
6A ADJUSTING THE CLOSING MECHANICAL STOPS
(DOUBLE LEAF)
The automatic door is supplied with the closing mechanical stops
installed on the mid-point of the support profile. If the door centre
requires adjustment, proceed as follows:
• Check if the mechanical stops are at the centre of the
profile.
• Take the leaf or leaves into the closing position.
• Loosen
the 2 bolts of the carriages (Fig.33 ref.).
• Take the carriage close to the contact point until the two
touch.
•
Tighten again the 2 bolts securing the carriages.
Tighten again the 2 bolts securing the carriages.
6.1A ADJUSTING THE CLOSING MECHANICAL STOPS (SINGLE
LEAF)
The automatic door is supplied with the closing mechanical stops
installed on the support profile. As the leaves close, make sure that
the carriages come into contact with the mechanical stops.
fig. 33
To Next Page
Loading...
