FAAC A140 AIR Series - Fitting the Electronics Module and Motor Unit

20
B


A



ENGLISH
fig. 35
fig. 36
8A FITTING THE ELECTRONICS MODULE AND THE MOTOR UNIT
Then insert the electronics module and secure it using the two rod bolts. (fig.35 B  
Insert 3 small plates sideways of the profile and secure the motor with the 3 screws to the support profile (fig.35 A  ).
On the motor bracket there is a gauge with a belt lift-proof function (fig.35 A  )
9A FITTING THE TRASMISSION PULLEY UNIT
insert the transmission pulley unit fig.36 ref 