FAAC E720 - Product Compliance Declaration; Essential Safety Precautions; Safety Guidelines for Installation & Use

1
ENGLISH
CONTENTS
WARNINGS
• Attention! To ensure the safety of people, it is important that you read all the following instructions.
• Incorrect installation or incorrect use of the product could cause serious harm to people.
• Carefully read the instructions before beginning to install the product and keep for future reference.
• The symbol highlights notes that are important for personal safety and the protection of the automated
system.
• The symbol
calls your attention to notes on product specifications or operation.
EC DECLARATION OF CONFORMITY
Manufacturer: FAAC S.p.A.
Address: Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
Declares that: Electronic device E720
• conforms to the essential safety requirements of the following EEC directives
2006/95/EC Low Voltage Directive
2004/108/EC Electromagnetic Compatibility Directive
Additional note:
This product has undergone testing in a typical
standard configuration (all products built by FAAC S.p.A. )
Bologna, 01-05-2010
The Managing Director
A. Marcellan
1 WARNINGS ..................................................................................................................................................... 2
2 LAYOUT AND COMPONENTS ........................................................................................................................... 2
2.1 COMPONENT DESCRIPTION ...................................................................................................................................... 3
2.2 DESCRIPTION OF TERMINAL BLOCK J13 .................................................................................................................... 3
3 TECHNICAL SPECIFICATIONS .......................................................................................................................... 3
4 ELECTRIC CONNECTIONS ............................................................................................................................... 4
4.1 BUS-2EASY PHOTOCELLS ............................................................................................................................................ 5
4.1.1 ADDRESSING BUS-2EASY PHOTOCELLS ..........................................................................................................................5
4.1.2 STORING BUS-2EASY ACCESSORIES .............................................................................................................................5
4.2 TRADITIONAL PHOTOCELLS ....................................................................................................................................... 5
5 PROGRAMMING ............................................................................................................................................ 7
5.1 1
st
LEVEL PROGRAMMING ........................................................................................................................................ 7
5.2 2
nd
LEVEL PROGRAMMING ........................................................................................................................................ 9
6 STORING RADIO CODE ................................................................................................................................11
6.1 STORING DS RADIOCONTROLS ............................................................................................................................... 11
6.2 STORING SLH RADIOCONTROLS ............................................................................................................................. 12
6.3 STORING LC/RC RADIOCONTROLS (ONLY FOR SOME MARKETS) ............................................................................ 12
6.3.1 STORING LC/RC RADIOCONTROLS REMOTELY ...........................................................................................................12
6.4 RADIOCONTROLS DELETION PROCEDURE .............................................................................................................. 12
7 OPERATIONAL START-UP ...............................................................................................................................13
7.1 CHECKING THE LEDS ................................................................................................................................................ 13
7.2 POSITIONING LIMIT SWITCHES ................................................................................................................................ 14
7.3 SETUP ....................................................................................................................................................................... 15
8 TESTING THE AUTOMATED SYSTEM ................................................................................................................ 15
9 ALARM AND ERROR SIGNALS ....................................................................................................................... 15
9.1 ALARMS ................................................................................................................................................................... 15
9.2 ERRORS .................................................................................................................................................................. 15
10 FUNCTION LOGICS .................................................................................................................................... 16