FAAC S418 - 1 Description

To Next Page

To Previous Page

ENGLISH

S418 AUTOMATED SYSTEM

1. DESCRIPTION

The S418 automated system for swing-leaf gates is an electromechanical operator which transmits its movement to the leaf by means

of a Worm-screw system.

The irreversible system guarantees mechanical locking of the leaf when the motor is not operating. An easy-to-use release device

permits movement of the leaf in case of malfunction or a power cut.

The low-voltage operation permits buffer batteries to be connected, thus compensating for temporary power cuts.

The adjustable rear bracket permits the operator to be installed on the most varied types of gates.

Correct operation and the stated features are only obtained using accessories, safety devices and control unit from FAAC.

The lack of a mechanical clutch device requires, in order to guarantee the necessary anti-crushing safety system, the use of a

control unit with adjustable electronic clutch.

The S418 automated system has been designed and constructed to control vehicle access in residential units; any other use must

be avoided.

Fig. 1

1.1. DIMENSIONS

Fig. 2

Part Description Part Description

1 Operator 6 Power cable

2 Release device 7 Front bracket

3 Mechanical stop at closing 8 Adjustable rear bracket

4 Mechanical stop at opening 9 Rear fitting