To Next PageTo Next Page
Need help?Do you have a question about the FAAC 750 Standard and is the answer not in the manual?
General| Model | 750 Standard |
|---|---|
| Max Gate Length | 5 m |
| Operating Temperature | -20°C to +55°C |
| Cycles per hour | 30 |
| Battery Backup | Optional |
| Operating Voltage | 230V AC |
| Power Supply | 230 Vac |
| Opening Time | 15-30 seconds |
Safety considerations for gate placement and structural integrity to prevent traffic hazards.
Precautions and requirements for safe installation of gate operators to prevent injury or death.
Guidelines for safe operation and maintenance of the gate operator system to prevent misuse.
Technical specifications for the 750 operator, including dimensions, power, and oil requirements.
Information on the 450 MPS control panel, including voltage requirements and available logics.
Instructions for unpacking the power unit and drive unit and identifying all components.
Overview of the 750 operator's capabilities, construction, and locking features.
Explanation of available operating logic modes for the 450 MPS control panel.
Tables detailing gate behavior for A, S, B, E, EP, C logic modes.
Criteria for gate leaf preparation before installing the 750 operator.
Guidelines and dimensions for preparing concrete footings for the gate operator.
Instructions for mounting and connecting the power unit box.
Steps for positioning and welding the drive unit mounting brackets.
Procedures for connecting hydraulic lines between the drive and power units.
Steps to synchronize the hydraulic system after connecting lines.
Instructions for installing the gate leaf shoe, including shear-pin assembly.
Procedure for installing the gate leaf onto the drive unit and hinges.
Instructions for connecting the main power supply to the control panel.
How to connect a single activating device to the control panel.
Wiring instructions for connecting the gate operator to the control panel.
Critical steps for adjusting hydraulic pressure settings on the operator.
Procedure to verify the correct rotation direction of the operator motor.
Guidance on connecting additional accessories like reversing devices.
Configuration of DIP switches for operating logic and gate behavior.
How to adjust potentiometers for torque, pause time, and operation time.
Critical steps to remove air from the hydraulic system for proper operation.
Procedure for adjusting bypass valves to set safety pressure limits.
Instructions for installing an extension arm for specific gate configurations.
Recommended maintenance schedule for checking oil and pressure settings.
Note that the control panel requires no maintenance.
Steps to diagnose why the gate does not respond to an activating signal.
Troubleshooting steps for a radio-controlled opener not opening the gate.
Diagnosing and resolving issues with jerky gate movement or oil problems.
