Need help?Do you have a question about the FAAC 615 and is the answer not in the manual?
General| Usage | Residential |
|---|---|
| Motor Voltage | 230 Vac |
| Operating Temperature | -20°C / +55°C |
| Gate Type | Swing |
| Cycles per Hour | 30 |
| Power Supply | 230V AC |
Crucial safety notes for users and product integrity.
Emphasizes reading instructions before installation for safe operation.
Warning about dangers of packing materials for children.
Recommendation to keep instructions for future reference.
Defines intended use and risks of misuse.
FAAC's disclaimer for misuse or unintended applications.
Prohibition of installation in explosive atmospheres due to safety risks.
Requirements for mechanical parts to meet EN standards.
FAAC's non-responsibility for closing element integrity.
Installation must adhere to EN standards for safety.
Mandates cutting power before system maintenance.
Specifies requirements for the mains power supply and protection.
Requirement for a differential switch for system protection.
Importance of a correct earthing system for safety.
Details the intrinsic anti-crushing safety device and torque control.
Specifies safety devices for mechanical risks like crushing.
Recommendation for indicator lights and warning signs.
FAAC's disclaimer for using non-FAAC components.
Emphasizes using only original FAAC parts for maintenance.
Strictly prohibits modification of system components.
Installer must provide manual operation info and handbooks.
Prohibits presence of people near operating product.
Keep remote controls away from children to prevent accidental activation.
Transit is only allowed when the automated system is idle.
Users must not attempt repairs; contact qualified personnel.
Recommends bi-annual checks of system efficiency and safety devices.
States that anything not specified is not permitted.
Defines maximum work time based on use frequency and temperature.
Checks before installation for safety and proper operation.
Instructions for preparing the foundation plate masonry.
Steps for mounting the main barrier upright.
Procedure for attaching the barrier beam to the upright.
Guide for fitting and adjusting the beam's balancing spring.
Table for selecting springs for rectangular beams with skirts.
Table for selecting springs for beams with feet and skirts.
Spring selection for the 615BPR RAPID model.
Table for selecting springs for round bar beams.
Procedure to convert the barrier from right-hand to left-hand configuration.
How to adjust the hydraulic system's torque for opening/closing.
Setting the physical end-stops for beam travel.
Adjusting the point where the slow-down movement begins.
Final checks and handover procedures for the installed system.
Accessory to increase beam visibility, requires spring adaptation.
Kit to articulate beams, requires spring adaptation.
Support to prevent beam bending and allow resting when closed.
Foot to support the beam when closed, requires spring readjustment.
To Next Page
