MAP2 / MAP2LCLG-SL
FABER-COM srl - Via Romana 36/1 - 42028 Poviglio (RE) - Italy Tel. +39-0522-960428 Fax. +39-0522-969644 - www.fabercom.it
\Prodotti\Limitatore CLG\PCLG-LxE[CLG-SL- Barra LED]\Documenti\SM#Limitatore CLG-SL_v102 - 19/04/2017
1
1
2
2
3
3
4
4
4
1
2
1
2
1
2
2
3
4
5
5
5
5
5
1
3
4
5
7
Page 6 / 6
Here below you can see a table to summarize the green led blinking and a brief description of the related error.
Error code
CLG STATE
CLG STATE
DESCRIPTION
DESCRIPTION
BLINKING
BLINKING
WORKING
STATE
AUTOTEST
ANY TIME
Slow sequence
Fast sequence
Input from transducer 1 exceedes the
maximum working limit.
Input from transducer 2 exceedes the
maximum working limit.
Input from transducer 1 is lower than
minimum working value.
Input from transducer 2 is lower than
minimum working value.
The current value on the valve 1 is outside
the normal working range.
The current value on the valve 2 is outside
the normal working range.
The input transducer 1 is in protection mode.
The input transducer 2 is in protection mode.
Relay broken because of the welded
contacts.
FLASH MEMORY ERROR.
It is not possible to close the relay. The
outputs are not powered.
There is current flowing on the valve coil
even though the CLG is not driving the
related output.
There is current flowing on the transducer
even though the CLG gives no power to it.
There is current flowing on switches
even though the CLG gives no power to it.
LED 100% + LED 90% blinking together
Emergency button pressed
To Previous Page
Loading...
Need help?
General