Factor O2 - Barstem Di2 Routing; Handlebar Di2 Cable Connections

Route the rear shifter cable.
Connect the JC-130 and rear shifter cable to the Shimano
RS910.
Route the JC-130 through the handlebar. Note that the cables
to both the front shifter and the JC-200 need to be pulled
through at the same time.
Assembly Manual 08
5-1 5-2 5-3
Barstem Di2 routing
Shimano
JC-130
to the frame
(Shimano JC-200
or EW-WU111)
to Shimano
EW-RS910
plug
to the
left shifter
to Shimano
EW-RS910
plug
to the
right shifter
Install RS910 into the barstem
5-4
Shimano
EW-RS910