Fagor 101S - Deleting Block Contents; Deleting the Whole Program Memory

Section:Chapter: 4
Page
PROGRAM EDITING6
4.1.3 DELETING BLOCK CONTENTS
Two cases may occur when attempting to delete the contents of a program block:
1.- The currently selected block number (upper display) is not desired one. Proceed as
follows:
* Press [CL] twice to clear both displays.
* Enter the desired block number and...
* Press [DELETE].
2.- The currently selected block is the desired one. The upper display may be blinking
(insert mode) or not. In either case...
* Press [DELETE]
In both instances, the block will stay selected but empty (the lower display being blank).
When scrolling the program blocks, this block will no longer be displayed.
4.1.4 DELETING THE WHOLE PROGRAM MEMORY
When you wish to delete the whole program memory take the following steps:
* Press key
to access the Aux-Mode operation mode.
* Press the following key sequence:
[1] [CL] [CL] [DELETE] [1] [DELETE]
To be able to delete the program memory this has to be unlocked.
BLOCK DELETE