Fagor 101S - Page 5

Section Page
6.6 Additional preparatory functions ......................................................................................... 21
6.6.1 Dwell (G04) .......................................................................................................................... 21
6.6.2 Increment part counter (G45)................................................................................................ 21
6.6.3 Round corner (G05) and square corner (G07)....................................................................... 22
6.7 Special functions .................................................................................................................. 23
6.7.1 Feedback inhibit (G47, G56) ................................................................................................ 23
6.7.2 G47, G48 as opening of the axis loop .................................................................................. 24
6.7.3 The feedrate "F" is not affected by "P18" (G61, G62)........................................................... 25
6.7.4 Acceleration ramp modification (G93)................................................................................. 25
6.8 Other functions ..................................................................................................................... 26
6.8.1 Batch programming (G81).................................................................................................... 26
6.8.2 Probing (G75) ....................................................................................................................... 28
6.8.3 Rigid tapping (G84, G80)..................................................................................................... 29
6.8.4 Loading the punch sizes (G60)............................................................................................. 32
6.9 Parametric programming ...................................................................................................... 33
6.9.1 Assignments ......................................................................................................................... 33
6.9.2 Operations ............................................................................................................................ 34
6.9.3 Access to the arithmetic parameter table .............................................................................. 37
6.9.4 Unconditional jump function (G25)..................................................................................... 39
6.9.5 Conditional jump functions (G26, G27, G28, G29) ............................................................. 41
ERROR CODES