Fagor 3WCI-8630N - Installation and Operating Conditions of the Appliance

31
• Disable the appliance before disposing of it. Unplug the
appliance from the power supply and cut o the power
cord. To prevent children or animals from being trapped in
the appliance, remove the doors, hinges and locks.
INSTALLATION AND OPERATING
CONDITIONS OF THE APPLIANCE
• Connect the appliance to the power supply 24 hours after unpacking and setting
in the nal location.
• Take the product out of the package, remove the scotch tape protecting the door
and the equipment. Any remaining adhesive stains may be removed with a mild
washing agent.
• Clean the interior surface of the cooler and the elements of the equipment with
a washing agent dissolved in lukewarm water, then wipe it dry.
• Place the cooler on an even, at and stable surface, in dry, aired and shaded
room, far from the heat sources such as: oven, hob, central heating radiators,
central heating pipes, hot water installation, etc.
• On the exterior surface of the product may be a protective foil, this foils should
be removed.
• Make sure the appliance is placed in a horizontal position by screwing in the 2
adjustable front legs (g. 1)
• Keep free space on the sides and rear of the appliance (see installation drawing)
• When you install your wine cooler inside a furniture cabinet, make sure that the
ventilation grille located in the bottom of the appliance is not blocked.
• Odours may be released when you rst start your appliance. It will dissipate
when the interior of the appliance cools down
• When you rst start your wine cooler, the compressor will run continuously until
the desired temperature is reached inside the chamber
• When you unplug your appliance from the power supply, it is recommended to
wait 5 minutes before you plug it back in. This will reduce the risk of damage to
the compressor.
• On selected models, the correct temperature will be shown on the display only a
few hours after the wine cooler has been put into operation
• This appliance should be connected to AC 220-240V 50Hz supply socket. The
socket must be tted properly, and must be supplied with an earthing conduit
and a 10A fuse.
• It is a legal requirement that the appliance is properly earthed. The manufacturer
will not be held liable for any damage or injury which may result from the failure
to full this requirement.
• Do not use adapters, multiple sockets and two-wire extension leads. If it is nec-
essary to use the extension lead, it must be equipped with a protection ring and
a single socket and must have a VDE/GS safety certicate.
• If an extension lead is used (with a protection ring and safety certicate), its
socket must be located at a safe distance, away from the sinks, and must not be
in a place where it could be ooded by water or waste water.
• Make sure the appliance can be easily disconnected from the mains, either by
pulling the plug out of the mains socket, or by switching the two-pole switch o.