Fagor 8035-M - Page 158

 Installation manual
CNC 8035
4.
MACHINE PARAMETERS
Spindle parameters
(SOFT M: V15.3X)
(S
OFT T: V16.3X)
·158·
SHARE (P71)
Signal percentage that passes through the filter. This value must be equivalent to the percentage
overshooting of the resonance because it has to make up for it.
This parameter is only taken into account for the "anti-resonance (notch)" filter type.
INPREV1 (P72) OUTPREV1 (P73) INPREV2 (P74) OUTPREV2 (P75)
INPREV3 (P76) OUTPREV3 (P77) INPREV4 (P78) OUTPREV4 (P79)
When using a CAN servo system (only with DRIBUSLE = 0), these parameters set the gear ratios
in each range.
Parameters INPREV1 trough INPUTRE4 indicate the input speed for each gear.
Parameters OUTPREV1 through OUTPREV4 indicate the output speed for each gear.
Possible values
between 0 and 100
Default value: 100
f
Ar
SHARE=100(Ar-Ao)/Ao
Ao
Calculation example for a particular response of the machine.
When using a CAN servo system, if parameter NPULSES and parameters INPREV
and OUTPREV of all the gears are set with a ·0· value, the CNC will assume the
equivalent ones of the drive.
i